For all 1ZZFE, 2ZZGE, 3SGE Beams and 3SGTE (4th gen/Caldina) engines
This adaptor board lets you wire up virtually any engine management system to control your 1ZZFE, 2ZZGE, 3SGE Beams or 4th generation 3SGTE engine using the factory wiring harness. It is the same adapter box we used to sell as part of the Haltech Platinum 1000 plug-and-play kits, but it is now available for purchase directly so you can wire in the EMS of your choice -- Haltech, Hydra, AEM Pro, Wolf, Motec, MegaSquirt or any other.
The two-layer circuit board is laid out to minimize noise, and the outputs are labeled with each pin.
Very useful if you are swapping engines and want to run an aftermarket EMS with the bare minimum of cutting/splicing of the donor car's harness.
This will save you many hours in wiring up an EMS, and will preserve your factory harness so you can swap back and forth to the factory ECU at will.
As an added bonus, there is EGT amplifier circuitry onboard if you want to add a DIY EGT to your installation. I'll include a parts list.
What is included: bare adapter board only.
